Kct-6 Split Core Current Transformer with 5A/2.5mA 10A/5mA 20A/10mA

Kct-6 Split Core Current Transformer with 5A/2.5mA 10A/5mA 20A/10mA

The current transformer is divided into a current transformer for measurement and a current transformer for protection; the function of the current transformer for measurement is used to measure (charge) and measure the current of the operating device
Chat Now

Product Details

We have the most up-to-date production line of Ee13 Flyback Switching Transformer, Ground Fault Center Through CT, Single Phase Current Transformer at the moment, which guarantees the quality to meet industry standards and specifications. We taking advantage of experience workmanship, scientific administration and advanced equipment, ensure the product quality of production, we not only win the customers' faith, but also build up our brand. We practice integrity, law-abiding principle and continuous improvement, thus creating an influential enterprise abroad. We will continue to inherit corporate culture, cultivate talents and fulfill our social responsibility. Welcome all nice buyers communicate details of solutions and ideas with us!!

Introduction

The current transformer is divided into a current transformer for measurement and a current transformer for protection; the function of the current transformer for measurement is used to measure (charge) and measure the current of the operating device; the current transformer for protection mainly and the relay device Cooperate, when the line is short-circuit overload and other faults, provide a signal to the relay device to cut off the fault circuit to protect the safety of the power supply system.


Precision Current Transformer(001)


Absolute Maximum Ratings


Operating free air temperature range

-40ºC to 85ºC

Storage temperature range

-40ºC to 100ºC

Leads Information

24AWG UL1007 Lead wires

Leads length:105±5mm

Stripped and tinned

4±2mm

Advantages

1. High and low voltage completely isolated, high safety, excellent insulation performance, no iron core, eliminating magnetic saturation and ferromagnetic resonance.

2. Good anti-electromagnetic interference performance, no open circuit high voltage danger on the low voltage side.

3. Large dynamic range, high measurement accuracy and wide frequency response range.

4. Data transmission anti-interference ability.

5. Small size and light weight.

Precautions

1. When the current transformer is verified, the current ratio of the standard current transformer to the current transformer to be tested must be the same.

2. Strictly follow the wiring shown in the figure.

3. Before testing the transformer, you must first test whether the load box is accurate.

4. During the verification process, it is forbidden to open the secondary winding.

5. Demagnetize before the transformer is verified. The demagnetization line is shown in Figure 4.

6. Open the circuit twice, adjust the regulator evenly and slowly, so that the indication of the dial indicator increases from 0 to 100%, and then evenly and slowly drops to zero. Repeat this process 2 to 3 times. The secondary winding should be shorted before the power is turned off after the demagnetization is completed.

7. The wiring schematic diagram of the current transformer with current riser is basically the same as the above wiring diagram, except that the output winding of the current riser and the primary winding of the transformer are the same winding, and the rest are the same.

QQ图片20200716135417_meitu_1

Our Kct-6 Split Core Current Transformer with 5A/2.5mA 10A/5mA 20A/10mA is manufactured under the direction of high quality requirements, standard inspections and rich experience. We are confident to be your preferred partner with our in-depth understanding of customer needs, as well as continuous optimization of production quality management and after-sales service system. Our factory always adheres to the tenet of 'survive by quality and development by science and technology', and is trusted by customers with considerate service.

Inquiry

You Might Also Like